< or > - Amount detected is above or below
equipment detection limit |
A - Approximate end time of flow due to power failure |
A-01 - >400000 |
B-02 - BOD result calculated from COD analysis |
D-1 - Elevated reporting limit(s) due to dilution. This has no effect on the data. Sample result is considered valid. |
DET - Analyte Detected |
DRY – Sample results reported on a dry weight basis |
E - End time of flow due to equipment removal
from site |
IS - Insufficient Sediment within Sample |
J - Detected but below the reporting limit |
N/A - Data not available at this time |
ND - Analyte not detected at or above the reporting limit |
NR - Not Reported |
NST – No Sample Taken |
U - Undetected |
W-05 - Highest possible dilutions were made by the laboratory |
Qual – Qualifiers |
Q-5 - Seed correction outside desired limits. This has no effect on the data. Sample result is considered valid. |
Q11 - Insufficient sample for analysis of matrix spike. This has no effect on the data. Sample result is considered valid. |
RPD - Relative Percent Difference |
S-1 - Laboratory container pH was above desired amount. This has no effect on the data. Sample result is considered valid. |
TNTC - Too numerous to count |
U – Undetected |
W-05 - Highest possible dilutions were made by the laboratory |
|
|
|
BOD - Biochemical Oxygen Demand |
BRL - Below Reading Limit |
COD - Chemical Oxygen Demand |
TDS - Total Dissolved Solids |
TSS - Total Suspended Solids by EPA 160.2 |
PC - Sample results suspect due to post-calibration results |
**This data was only collected in the second permit term. |
***This data is only being collected in the third permit term. |
|